Spaces

Weekly chat review checklist for hardware makers

This checklist helps a hardware maker review a week of chats handled by an AI agent, checking part matches, stock answers and hand-overs. It takes about twenty minutes and keeps answers accurate.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

Hardware catalogues change more than people expect. A finish is dropped, a pack size moves from ten to twenty, a supplier delay pushes a lead time out. An AI agent keeps repeating whatever it was last told, so a short weekly look at real chats keeps old facts from slipping through to customers.

Set aside twenty minutes on the same day each week. Open a handful of chats, work through the list below and jot down what to change. The owner, the sales lead or the person who looks after technical questions can all do it well.

Tick each one as you go. 0 of 10 done.

[ ] Read five chats where a customer asked about a part code or size.
[ ] Check every answer about stock against what was really on the shelf.
[ ] Look at chats where the agent said it was not sure.
[ ] Count the chats handed to a person and how fast each got a human reply.
[ ] Check that no fire door or lock security advice was given by the agent.
[ ] Note any part the agent could not identify from a photo.
[ ] Check finish and colour answers matched your current range.
[ ] Look for chats that went quiet after a quote or a part suggestion.
[ ] Update the information sheet with every change from the week.
[ ] Tell the sales team about anything they need to act on.

What to look for in a chat

You are not reading for style. You are reading for facts. Was the part code right? Was the size one the customer asked for? Did the chat end with a clear next step? A reply that sounds friendly but names the wrong hinge is worse than a plain correct one.

If you spot the same issue twice, treat it as a gap in the information, not as a one-off. Fix the source and note the date, so you can see later whether it helped.

A simple note to keep

Keep a running page with three short lists, and read it at the start of each review.

  • Parts or finishes that changed this week.
  • Questions the agent could not answer.
  • Chats a person took over, and how they ended.

FAQ

How many chats should I read each week?

Five to ten is enough for most makers if you pick a mix: a few part questions, a few stock questions and every handed-over chat. Read more in the weeks after you change a range.

Who in the business should do the review?

Someone who knows the catalogue well, such as the sales lead or the technical person. They will spot a wrong part code in seconds, which a general reader might miss entirely.

What should I do when I find a wrong answer?

Fix the information the agent reads, then check a similar question gives the right answer. If the customer was misled, a person should write to them and put it right.

More free tools for hinge, lock and fittings makers

Read the guide: Answer finish, size and trade order questions for your hardware business.