Spaces

Weekly chat review checklist for machinery service and parts teams

This checklist gives a machinery maker a short weekly routine for reading the conversations the AI agent handled. It helps you spot wrong answers, missing documents and chats that waited too long.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

A machine support desk changes with the seasons, the product range and the fleet in the field. A new model arrives, a part is replaced by another, a regional dealer changes hours. Your agent only knows what you tell it, so a short weekly look at its chats keeps its answers true.

Set aside half an hour, ideally on the same day each week. Open a handful of chats from each type: parts, service, sales and dealers. Tick off the points below and write down one change to make before next week. Small steady corrections matter more than a big yearly clean-up.

Tick each one as you go. 0 of 10 done.

[ ] Read five parts chats and check the part number was right.
[ ] Read five service chats and check the summary reached the technician.
[ ] Count chats that went to a person and how long each waited.
[ ] Look for chats where the serial number was not obtained.
[ ] Note questions asked more than three times.
[ ] Check that no chat gave a diagnosis or safety advice.
[ ] Check that dealer and factory routing was right.
[ ] Update hours, contacts and stock notes that changed this week.
[ ] Read any chat where the customer sounded unhappy.
[ ] Write down one change to make before next week.

What to look for in each chat

Read as the customer would. Was the first reply clear? Did it ask for the model and serial number? Did the person feel looked after, even when the answer was that a technician would call? A kind, short reply to a stopped machine builds loyalty that lasts for the life of the equipment.

Then read as your technician would. Did the summary hold the model, serial, symptoms, photos and location? If a technician had to ask again, add that question to the intake list.

Patterns worth acting on

A few patterns show up again and again.

  • A spike in one fault after a new model release.
  • Many questions about a manual that is hard to find.
  • Evening messages from regions with no on-call person.
  • A dealer who sends the same question every week.

FAQ

How long should the weekly review take?

About half an hour is enough for most machinery teams. Pick a sample from each type of chat and read closely, rather than trying to read every single message.

Who should do the review?

Someone who knows your machines, such as a service lead or parts manager. They can spot a wrong part number or a bad piece of advice straight away.

What should I do when I find a wrong answer?

Fix the instruction or the document behind it, then test the same question again. If a customer was misled, a person should contact them and put it right.

More free tools for machinery makers

Read the guide: Answer parts and service messages for machinery makers.