Spaces

Enquiry-to-customer value estimator for pulp, paper and board mills

This estimator shows a pulp, paper or paperboard mill how many new customers its enquiries produce and what one more percentage point of enquiries turned into customers is worth over a year, using its own figures.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

Mill accounts are few and large. A single converter that buys every month can be worth more than hundreds of small customers elsewhere. That makes each enquiry valuable, and each slow reply expensive. A technical contact who waits two days for a data sheet may simply have signed with another mill.

Enter how many new buyer enquiries reach you each month, what share becomes a customer, and what a customer is worth over a year to your mill. Use the value of the account, not a single load. Treat the answer as a way to see the stakes, not as a forecast.

Every starting figure is an example. Change each one to your own.

Under your figures

Customers a month today3
Value a year today648,000
One more percentage point is worth, a year43,200

This is an estimate from your own figures, and it cannot predict how many extra enquiries an agent would turn into customers.

What the numbers mean

The result shows what your enquiries are worth now, and what one more point of conversion adds over a year. At a mill, a single extra account can be worth a great deal, so even a small gain in answered enquiries matters.

The estimate does not promise that an agent will lift your rate. It simply shows how much is at stake when replies are slow, vague or missing.

Where enquiries are lost

In the paper trade, a few habits cost accounts.

  • No reply to a technical question for more than a day.
  • Data sheets that are old or hard to find.
  • A sample request that waits for weeks with no word.
  • A reply that skips the question the buyer asked.
  • A chat that arrives overnight and gets no acknowledgement.

FAQ

What counts as an enquiry?

Count each new contact from a buyer or technical person asking about supply, grades or samples. Leave out drivers, repeat orders on existing accounts and general questions from brokers.

How do I find my share that become customers?

Look at the last six months of new enquiries and count how many placed an order. Divide the orders by the enquiries, and use that as your starting figure.

What value should I enter for a customer?

Use the average monthly sales from a new account in its first year, based on past accounts. If it varies widely, try a low and a high figure.

More free tools for pulp, paper and paperboard mills

Read the guide: Answer mill buyer and carrier messages without tying up the sales desk.