Spaces

Do and don't guide for your agent at a drilling or mining support firm

This guide gives a drilling or mining support firm a plain set of do and don't rules for its AI agent, covering clients, crews and suppliers, so the agent helps with logistics and leaves risky matters to people.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

An agent behaves the way you tell it to. For a firm that works on other companies' remote sites, that means being clear about what it can say on lead times and documents, and where it must stop and hand over to a project manager or safety lead.

Read each rule and edit it to match your firm. Then give the list to whoever sets up your agent. Re-read it every few months, because new clients and new kinds of work often need a new rule.

Tick each one as you go. 0 of 10 done.

[ ] Do answer in short, plain sentences that a tired crew member can read on a phone.
[ ] Do explain mobilisation steps and typical lead times in general terms.
[ ] Do list the documents a crew member needs for a named site.
[ ] Do ask where the site is and what kind of drilling before passing a lead on.
[ ] Do say plainly when a person will follow up and what they will do.
[ ] Don't give a price, day rate or quote of any kind.
[ ] Don't answer questions about injuries, incidents or site safety rules.
[ ] Don't describe ground, water or geological conditions at any site.
[ ] Don't promise a rig or crew is free on a specific date.
[ ] Don't share names, rosters or locations of crew or client prospects.

Turning a rule into a line the agent follows

Rules work best when they are concrete. Instead of "be careful with safety", write "If anyone mentions an injury, a spill or a stopped rig, tell them to call the emergency number and pass the chat to the safety lead at once."

Add one example for each rule. An example of a good reply and a bad reply teaches the agent far more than a general statement, and it makes your own review of chats much faster.

Tone for a rough-and-ready industry

Crews and site managers like directness. Aim for a voice that is friendly, brief and respectful.

  • Use first names where the sender does.
  • Skip jargon the sender did not use first.
  • Admit when you do not know and say who will find out.

FAQ

Why can't the agent mention any prices at all?

A quote depends on depth, ground, access and mobilisation distance. A rough number in chat can become a promise, so a project manager should always give the figure after scoping the job.

Should I add rules for each client site?

Yes, if sites differ a lot. A short per-site note on documents and access lets the agent answer crew questions correctly without guessing, and lets you update one site at a time.

How many rules is too many?

Around ten to fifteen clear rules is plenty. If the list grows long, group them by who is writing, such as clients, crew and suppliers, so each is easy to scan.

More free tools for mining support and exploration drilling firms

Read the guide: Answer client and crew messages at a drilling or mining support firm.