Spaces

Do and don't guide for your finishing mill's AI agent

This guide gives finishing and coating mills simple do and don't rules for their AI agent, covering capability, lead times, samples and faults. Use it to set the tone before the first buyer chat.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

Briefing an AI agent is like briefing a new sales coordinator on their first Monday. You would not say be helpful and hope for the best. You would explain which processes you run, what to promise about dates, and when to fetch the quality lead. The same clarity helps an agent.

Read each rule and edit it to fit your plant. Some will be obvious and a few may surprise you. Add your own at the bottom, then share the list with whoever sets up your agent, so its manner matches the way your best people speak to buyers.

Tick each one as you go. 0 of 11 done.

[ ] Do greet buyers warmly and use the name of the mill.
[ ] Do answer capability questions from your written process sheet only.
[ ] Do ask for fibre, width, length, finish and date on every new lot.
[ ] Do state minimum lots and width limits plainly and early.
[ ] Do say when a person will reply, with a real time.
[ ] Do collect the lot number and photos for any problem report.
[ ] Don't promise a slot on the dye or coating schedule.
[ ] Don't quote a price unless your team has given the agent the figure.
[ ] Don't say a lot is faulty, or that the mill is at fault.
[ ] Don't make claims about flame, water or abrasion performance.
[ ] Don't message anyone who has not written to you first.

Turning rules into habits

The best rule lists are short and specific. Replace a general line like be accurate with the exact thing you mean, such as only quote lead times from the sheet dated this week. Specific rules are easy for an agent to follow and easy for you to check when you read a chat.

Review the list once a quarter. New machines, new coatings or a changed minimum lot should show up here the same week.

Add rules from your own plant

Every mill has a few special cases. Think about adding rules for these.

  • A fibre or finish combination you refuse to run.
  • A customer who must always go straight to the owner.
  • A special instruction for export buyers about paperwork.

FAQ

How many rules should I give the agent?

Ten to fifteen clear rules work well. More than that and the important ones get lost. Keep each rule short and about one thing, and put the strictest ones first.

Can I change the rules later?

Yes, and you should. Read a week of chats, spot where the agent went wrong, and tighten the rule that caused it. Small changes each month keep replies on track.

What tone suits a mill?

Plain, calm and practical. Buyers want facts and a quick next step more than flourish. Write as your best coordinator would, short sentences and no hype.

More free tools for fabric finishing and coating mills

Read the guide: Answer fabric finishing and coating enquiries faster.