Spaces

Do and don't guide for your agent: finishing shop customers

This guide gives plain do and don't rules for an AI agent that answers plating, coating and heat treating customers. Owners can use it to brief the agent and the team.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

Customers of a finishing shop talk to your agent as if it were the person at the counter. That makes a few simple rules important: say what you do, be honest about timing, and leave the metallurgy to people. The list below turns those ideas into plain do and don't lines.

Read each line and decide whether it fits your shop. Edit the wording, add rules from your own close calls, and give the final list to whoever sets up your agent. Pin a copy at the counter so the team follows the same rules.

Tick each one as you go. 0 of 10 done.

[ ] Do answer plain questions about processes, sizes, drop-off times and what to send.
[ ] Do ask for the material, the finish wanted and the quantity.
[ ] Do say clearly when a person will confirm a date or a price.
[ ] Do keep replies short and written in plain words.
[ ] Don't recommend a treatment, coating thickness or hardness.
[ ] Don't promise a colour match against an earlier batch.
[ ] Don't give a price unless it is a published, fixed price.
[ ] Don't say a part is safe for load, pressure or critical use.
[ ] Don't blame the customer or the supplier when a batch fails.
[ ] Do hand over fast when a customer is upset, asks for a person, or the agent is unsure.

Why these rules matter in a finishing shop

In many shops, a wrong answer costs more than a slow one. A recommended finish that does not suit the alloy can ruin a whole batch. A promised colour match that does not match can cost a customer's trust.

Rules like these protect your agent as much as your customers. They give it clear edges, so it can be quick and confident inside them.

Rules to add from your own shop

Every shop has its own sore points. Think about adding lines such as these.

  • Do mention that masking must be marked on the parts.
  • Don't accept parts for a process we have not agreed in writing.
  • Do say when the next load for this process runs.

FAQ

Is it safe to let the agent answer anything about turnaround?

Only if it can read your batch schedule or your fixed ranges. Otherwise it should say a person will confirm, and when, rather than invent a date.

What if a customer pushes the agent to recommend a finish?

The agent should politely hold the line, collect the material and the use of the part, and pass the chat to your metallurgist or lead operator.

How often should we update these rules?

Review them every month or two at first, and after any complaint. Add a line whenever a close call shows a gap, and drop lines that no longer fit.

More free tools for plating, coating and heat treating shops

Read the guide: Answer finishing shop messages while the tanks and furnaces run.