Spaces

Weekly chat review checklist for plating, coating and heat treating shops

This weekly checklist helps a finishing shop owner review the chats an AI agent handled, spot wrong or vague answers and fix them. It takes about half an hour.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

A finishing shop changes week to week: new loads, a tank down for maintenance, a rush from a big customer. Your answers can go out of date quietly. A short weekly look at the conversations catches the stale answers before a customer is let down.

Pick the same slot each week, such as Friday after the last load goes out. Read through the chats with a pen in hand, tick the lines below, and write down any fact that needs changing. Thirty focused minutes is better than a long review you put off.

Tick each one as you go. 0 of 10 done.

[ ] Read every chat that was handed to a person.
[ ] Check that the quoted turnaround matched what really happened.
[ ] Look for questions the agent could not answer.
[ ] Check how fast a person replied after each handover.
[ ] Note any process the customer asked for that you do not offer.
[ ] Spot any chat where the agent suggested a finish or hardness.
[ ] Review every complaint about colour, flaking or lateness.
[ ] Check that drop-off and collection times in the notes are still right.
[ ] Update notes for tanks or furnaces down for maintenance.
[ ] Pick one change to make and write it down.

How to read a chat quickly

Look first at the last message in each chat. Did the customer end happy, or silent? Then look at the first reply and ask whether it answered the question. Most problems show up in those two places.

Keep a running note called Fix this week. Three or four lines is plenty, such as: add black oxide to the process list, say we are closed the Monday after the holiday.

Signs the notes need work

If you see these often, spend more time on the written answers.

  • The same question is handed over again and again.
  • Customers ask the agent to repeat the drop-off hours.
  • Turnaround answers that sound vague or hedged.
  • Customers asking for a person right away.

FAQ

How long should a weekly review take?

About half an hour for a busy shop. If it takes much longer, start by reading only the handovers and complaints, then add more as the routine settles.

Who should do the review?

Ideally the owner or the person who knows the processes best, such as the lead operator. They can spot a wrong answer about a finish quickly.

What if the review finds a bad answer sent to a customer?

Write to that customer yourself, correct it plainly, and fix the note that caused it. Honest corrections tend to build trust rather than lose it.

More free tools for plating, coating and heat treating shops

Read the guide: Answer finishing shop messages while the tanks and furnaces run.