Spaces

Do and don't guide for a lighting maker AI agent

This guide gives plain do and don't rules for an AI agent answering messages for a lighting maker. It covers codes, finishes, safety, project quotes and honest answers, and is meant for owners setting up their agent.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

An agent follows the rules you give it. For a lighting maker those rules matter more than usual, because a wrong word about a driver, a dimmer or a heat rating can lead to a failed install or a risky fitting. Clear do and don't lines are the easiest way to set the limits.

Read each line and adjust it to your range. Then copy the final version into your agent instructions. Each line is short on purpose, so your whole team can remember it and spot when the agent steps outside it.

Tick each one as you go. 0 of 10 done.

[ ] Do ask for the fixture code or a photo of the label before answering a technical question.
[ ] Do quote dimensions, finishes and options straight from your own sheets.
[ ] Do say clearly whether an item is in stock or made to order.
[ ] Do send the installation sheet when someone asks how to fit a product.
[ ] Do collect plans, quantities and the site date for project requests.
[ ] Don't give wiring, earthing or electrical safety advice.
[ ] Don't claim energy savings, lifetime or light output beyond your published figures.
[ ] Don't promise a delivery date that is not in your system.
[ ] Don't guess a driver or dimmer match when the table is silent.
[ ] Don't quote prices for projects, custom finishes or trade accounts.

Why short rules work best

Long policy documents tend to be skimmed. A short list of ten lines is read, remembered and checked. When you see the agent do something you dislike, add one line rather than rewriting the whole set.

The do lines tell the agent how to be useful. The don't lines mark where a person must step in. Both matter, and the balance is what makes customers trust the replies.

Add your own lines

Every maker has a few special cases worth writing down.

  • How you treat orders from trade accounts versus retail buyers.
  • What you say about outdoor or damp-location fittings.
  • Which custom finishes you are willing to discuss.
  • How you handle spare parts for discontinued fixtures.

FAQ

Where do I put these rules?

Paste them into the instructions you give your agent, or ask whoever sets it up to do so. Keep a copy somewhere your team can see, and review it each month as the range changes.

What if the agent breaks a rule?

Read the chat, then tighten the wording of that rule and add an example of the right answer. If it was a safety topic, also check that your hand-over route is working properly.

Can the agent be friendly and still follow these rules?

Yes. Rules limit what it claims, not its tone. A warm, brief reply that says I will ask our technical team is both kind and correct, and customers appreciate the honesty.

More free tools for lighting fixture and lamp makers

Read the guide: Answer designer and electrician messages for lighting fixture makers.