Spaces

Hand-over rules: what your foundry agent must pass to a person

This checklist sets out the foundry messages an AI agent must pass to a person, such as castability, alloy choice, price and quality disputes. Use it to write clear hand-over rules.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

A foundry sells judgement as much as metal. Whether a thin section will fill, whether a grade suits a load, whether a crack is a defect or within tolerance: these answers carry real cost and sometimes real safety risk. An AI agent can handle the routine, but it must know exactly where to stop and call a person.

Use this list to write your rules. Go through each item and decide who on your team takes it and how fast they should answer. Then tell your agent in plain words. Handing over early, with a short note, is always better than an agent guessing and a customer relying on the guess.

Tick each one as you go. 0 of 10 done.

[ ] Any question about whether a design can be cast, or how to change it so it can.
[ ] Any question about which alloy or grade to use for a job.
[ ] Any price, price change, tooling cost or discount request.
[ ] A complaint about porosity, cracks, shrinkage, wrong dimensions or a failed part.
[ ] Anything about a part that cracked or broke in use, or caused an injury or damage.
[ ] A request for test reports, material certificates or customer-specific standards.
[ ] A change to quantity, date or specification on an order already in the works.
[ ] News of a late pour, a failed batch or a scrapped casting.
[ ] A customer who is angry, threatens to cancel, or mentions legal action.
[ ] Requests to visit the shop, watch a pour or audit the quality system.

Make the hand-over useful

A hand-over is only good if the person receiving it can act at once. Ask the agent to leave a short note: customer name, part or order number, what was asked and what has already been said. Then the engineer or quality lead does not have to scroll back through the chat.

Also decide how long a hand-over may wait. A cracked part in a plant that has stopped needs minutes. A routine quote can wait until tomorrow morning.

  • Name one person per type of hand-over.
  • Set a target reply time for each.
  • Tell the customer a person is taking over and roughly when.

What the agent can still say

Even when handing over, the agent can be kind and clear. It can say it has passed the message to the right person, repeat the order number so the customer knows it was understood, and say when to expect a reply. It should not guess at causes or offer a fix.

FAQ

Is it too cautious to pass every price question to a person?

For most foundries it is right, because metal cost and scrap risk shift. The agent can still explain what affects price and what the person will need before giving a number.

What if a handover happens outside working hours?

The agent should tell the customer when the team is back and note the urgency. If you have an on-call contact for line-down emergencies, include that rule in your instructions.

Can the agent send certificates itself?

Only if your quality system lets it read and send the exact signed file for that heat or order. Otherwise it should hand the request to your quality lead, who confirms what exists.

More free tools for foundries and casting shops

Read the guide: Answer enquiry and casting status messages for your foundry.