Spaces

Weekly chat review checklist for tooling and machine makers

This weekly checklist helps tooling and machine makers review the buyer chats their AI agent handled. It finds wrong codes, stalled quote requests and slow hand-overs before they cost orders.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

A weekly look at the chats is the cheapest quality control you will ever run. Buyers rarely tell you when an answer was unclear. They just stop writing. Reading a sample of conversations shows you where the catalogue data is thin and where your team replied too slowly.

Set aside thirty minutes, for example on a Friday afternoon when the counter is quieter. Work down the list with a handful of chats open. Note what you find in one shared document, and fix the biggest gap first before the next week starts.

Tick each one as you go. 0 of 10 done.

[ ] Read five catalogue chats from start to finish.
[ ] Check that each tool code the agent gave matched the request.
[ ] Look at every chat that was passed to a person.
[ ] Measure how long each hand-over waited for a reply.
[ ] Find custom tooling requests that arrived without a part file.
[ ] Check that quote requests reached the estimator in full.
[ ] List new questions you had no written answer for.
[ ] Look for any speed, feed or tolerance advice the agent gave.
[ ] Check open sample, repair and status questions for an update.
[ ] Pick one fix and write down who will do it by Monday.

What to look for

You are not hunting for blame. You are looking for patterns. If three buyers ask about the same insert and the agent hesitates each time, your catalogue entry is missing something. If two quotes stalled at the drawing stage, the intake question needs plainer words.

Keep a simple tally from week to week: chats handled, chats handed over, and average wait for a person. Rising numbers tell you where to put effort.

Habits that make the review stick

Small habits keep this from becoming a chore.

  • Do the review at the same time each week.
  • Share one finding with the team in the Monday huddle.
  • Update the written answers the same day you spot a gap.

FAQ

How many chats should I read each week?

Five to ten is enough for most shops. Choose a mix of catalogue chats, custom tooling requests and every chat passed to a person, so you see the whole range of buyers.

Who should do the weekly review?

Ideally the owner or the counter lead, with an engineer joining now and then. The person who knows your catalogue best will spot wrong answers fastest.

What if I find a wrong answer in an old chat?

Correct the written source so it does not repeat, then contact the buyer yourself if the mistake could cost them money or time. Buyers value an honest fix.

More free tools for machine tool, mold and cutting tool makers

Read the guide: Answer tooling and machine tool messages for metalworking suppliers.