Spaces

First-reply checklist for door, window, pallet and millwork enquiries

This checklist shows what the first reply to a new door, window, trim, flooring or pallet enquiry should contain, so the customer gets a useful answer and you get the measurements you need. It is made for wood product shops and their AI agent.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

A wood product enquiry rarely starts with hello. It starts with a size, a photo of a rotten sill or a line like "can you do 300 pallets by Monday". The person writing is usually mid-job, standing in a doorway with a tape measure, and will message the next shop if yours stays quiet.

Read each point and tick the ones your replies already do. Every gap is a place where a quote stalls or a wrong cut gets made later. Pin it by the saw, or hand it to whoever sets up your AI agent so the first reply follows the same shape every time.

Tick each one as you go. 0 of 10 done.

[ ] Say plainly whether you make the kind of product asked about.
[ ] Name the standard sizes, species or profiles you keep.
[ ] Ask for the missing measurement, one figure at a time.
[ ] Ask for a photo or a sketch when the job is a repair or a match.
[ ] Give the usual lead time for that product line.
[ ] Ask whether the order is made to measure or from stock.
[ ] Ask where the goods are going and how they will be collected.
[ ] Ask what the finish or treatment should be.
[ ] Say who will confirm the final size and the price.
[ ] Close with one clear next step.

What a good first reply sounds like

Imagine a carpenter writes: "Need a 36 inch oak exterior door." A good reply from {business} says yes, 36 inch is a standard width, the lead time is about three weeks, and could they measure the opening again and send a photo of the frame. That is four useful things in three short lines.

Notice what is missing. There is no price guessed, no promise that the size will fit, and no long tour of everything you make. The agent collects, and a person confirms.

Slips that cause remakes

These are the most common ways a first reply sets up a costly mistake later.

  • Accepting "about 36 by 80" as the final opening size.
  • Quoting a lead time without checking whether the species is in stock.
  • Forgetting to ask whether the job is new work or a match for something old.
  • Writing a long reply that hides the one question you needed answered.

FAQ

Should the first reply include a price?

Only if the item is a standard one with a fixed price in your list. For made to measure work, collect the details first and let a person price it once the size is confirmed.

What if the customer sends a photo and nothing else?

Thank them, say what you can see, and ask for the one figure you still need. Then pass the photo and the question to your estimator so it is not lost.

How quickly should we answer a new enquiry?

As soon as you can, ideally within minutes. Trade buyers often compare two or three suppliers at once, and the first useful reply usually gets the measurements and the order.

More free tools for millwork, window, pallet and wood product makers

Read the guide: Answer door, window, pallet and millwork enquiries while the saws keep running.