Spaces

First-reply checklist for drilling and well service crews

This checklist shows what the first reply to a new message from an operator, crew member or supplier should include, so a call-out request gets a useful answer fast. It is made for drilling, well service and mining support contractors.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

When an operator writes asking for a unit or a crew, they are often comparing two or three contractors at once. The one that answers first with the right questions usually gets the bid conversation. A slow or vague reply sends them down the list, and your yard hears nothing more.

Read each point and tick the ones your team or your AI agent already does. The gaps are where work slips away. Pin the list in the dispatch office or read it out at the weekly planning meeting, then check a handful of real replies against it.

Tick each one as you go. 0 of 10 done.

[ ] Greet the sender and name your company.
[ ] Ask for the site, region or block in the first exchange.
[ ] Ask what service is needed: drilling, servicing, pumping, logging or site work.
[ ] Ask for the rough scope, such as depth, metres or number of wells.
[ ] Ask for the date they want the crew on site.
[ ] Ask for a name and a direct number for the site contact.
[ ] Say who will reply and by when.
[ ] Do not quote a rate or promise a unit in the first reply.
[ ] Point safety or incident messages straight to the safety contact.
[ ] Keep it short enough to read on a phone in a truck cab.

What a strong first reply sounds like

Think of your best dispatcher on a busy morning. They answer plainly and ask only what they need. For example: Hi, thanks for writing to {business}. We run core and water well rigs in the northern region. Which site is this for, and roughly how many metres?

That one reply tells the sender they are in the right place, and it starts the scoping. Your operations lead then picks up a chat that already holds the basics instead of starting from a bare request.

Slips that cost you jobs

These are common in contractor chats.

  • Sending a long brochure paragraph when the operator asked one question.
  • Asking for ten documents before saying whether you can do the work.
  • Saying yes to a start date before checking the crew calendar.
  • Leaving a message sitting over a weekend when a rig move is planned.

FAQ

How fast should we reply to an operator who wants a crew?

As fast as you can, since many operators ask several contractors at once. Even a short acknowledgement with two scoping questions within minutes keeps you in the running while the full answer is prepared.

Should the first reply say whether a rig is free?

Only if your agent can read your live crew or rig calendar. Otherwise it should collect the scope and dates, then tell the sender that a named person will confirm availability and give a time.

What if the sender never answers our questions?

Leave the chat open and send one polite nudge if the request looked serious. They wrote to you first, so one reminder is fine, but do not keep chasing a message that has gone quiet.

More free tools for drilling and well service contractors

Read the guide: Answer operators and crews for a drilling or mining support contractor.