Spaces

Hand-over notes for engine, gearbox and drive makers

These hand-over notes show the short summary an agent leaves for a person at an engine, gearbox or drive maker. A good note means the customer never has to repeat the plate details or the fault.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

When a technical chat moves from an agent to an engineer, the first minute matters. If the engineer must scroll through twenty messages to find the model and the fault, the customer waits longer and gets annoyed. A short note puts everything at the top.

Choose the note that fits the kind of hand-over, fill in the person it goes to and the unit, and keep the format the same each time. Then your team always knows where to look for the serial number, the fault and what has been promised.

Rating or selection question

For [to]: a customer at a plant is asking whether [unit] can take a higher load than published. The agent gave only the published rating and has told them an engineer will reply.

Failure report

For [to]: [unit] has failed at a customer site. The agent has asked for hours run and photos, and has said sorry for the downtime. No cause or warranty answer has been given.

Spares request ready to quote

For [to]: the customer wants spares for [unit]. The plate photo is attached and the code matches our range. The agent has not given a price. Please quote and confirm stock.

Customer asked for a person

For [to]: the customer chatting about [unit] asked to speak with a person. The agent has told them you will reply. The chat so far is below, with nothing promised.

What every note should hold

A good note answers four things at a glance: who is the customer, what is the unit, what do they want, and what has already been said. Anything the agent promised or refused to promise should be in the note too.

Mark urgency clearly. If the machine is stopped or a safety issue is involved, put that on the first line so the engineer sees it before anything else.

Keep the format steady

A steady format makes notes quick to read.

  • Start with who the note is for and how urgent it is.
  • Give the unit model and serial number on one line.
  • State what has been said and what has not.

FAQ

How long should a hand-over note be?

Three or four lines is plenty. The engineer can read the full chat below if needed. The note is there so they know within ten seconds what the customer needs and how urgent it is.

Should the note say what the agent told the customer?

Yes, especially anything about delivery, price or fit. If the agent said nothing on those, say that too, so the engineer knows they are starting fresh.

Who reads the notes outside working hours?

Decide this with your team before you start. A named person should read the overnight notes first thing, with stopped-machine and safety notes at the top of the pile.

More free tools for engine, gearbox and drive makers

Read the guide: Answer messages for engine, gearbox and drive component makers.