Spaces

Weekly chat review for engine, gearbox and drive makers

This checklist walks an owner through a weekly look at the chats an AI agent handled, checking part matches, lead times and hand-overs. It is made for makers of engines, gearboxes and drive components.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

A weekly review catches small problems before they become returned parts. In your trade the usual slips are a near-match code, an out-of-date data sheet or a lead time that has quietly changed. None are obvious until someone reads the chats with fresh eyes.

Set aside thirty minutes at a regular time, such as Friday afternoon once the shipping rush has eased. Read a handful of chats from each kind of request, then tick through the list. Write down any fix and make it before Monday.

Tick each one as you go. 0 of 10 done.

[ ] Read five chats where a part was matched from a plate or old code.
[ ] Check every chat that was handed to an engineer.
[ ] Note how long hand-overs waited for a person.
[ ] Look for questions the agent could not answer.
[ ] Check that lead times and stock statements are still true.
[ ] Confirm data sheets sent are the current revisions.
[ ] Look for any chat that touched safety, load or warranty.
[ ] Count spares and service requests that arrived with full details.
[ ] Spot customers who asked the same thing twice.
[ ] Write down two changes to make before next week.

What to look for in a technical chat

Read for the customer, not for the agent. Did the maintenance lead get what they needed in as few messages as possible? Did a person take over at the right moment? A chat that ended with a data sheet sent and a spares request raised is a good one.

Pay special attention to chats where the customer sounded stressed. Those are the stopped-machine chats, and your speed and clarity there shape how they remember you.

Keep a simple log

A running note helps you see patterns over a month.

  • Codes that people often mistype, so you can add them to your list.
  • Products customers ask about that you do not make.
  • Times of the week when hand-overs wait longest.

FAQ

How many chats should I read each week?

Ten to twenty is enough for most makers, with a mix of easy ones and every hand-over. If you are busy, read all the chats that involved a part match, since those carry the most risk.

Who should do the review?

Ideally the owner or a parts desk lead, with an engineer joining for ten minutes to check technical answers. Someone who knows your range will notice a wrong match straight away.

What if I find a wrong answer in the chats?

Fix the source, such as the cross-reference list or a guide, and contact the customer if the answer could cause an order or fit problem. Then note it so the same slip does not return.

More free tools for engine, gearbox and drive makers

Read the guide: Answer messages for engine, gearbox and drive component makers.