Spaces

Do and don't guide for your agent: machine shops and fastener makers

This guide gives plain do and do not rules for an AI agent answering buyers at a machine shop or fastener maker. Use it to write instructions that keep the agent helpful and safe.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

An agent works best with clear rules, the same as a new office hire on their first morning. In a shop the rules are practical: what to say about materials and size, what to ask for on a quote, and what never to promise without the estimator looking at the drawing.

Read each rule and adjust the wording for your own shop. Then pass the finished list to whoever sets up your agent. Keep it short enough that your team could read it in two minutes, because a rule nobody remembers does not help anyone.

Tick each one as you go. 0 of 10 done.

[ ] Do state the materials you cut and the largest part you can machine.
[ ] Do ask once for any missing detail: material, quantity, finish and date.
[ ] Don't quote a price for a machined part.
[ ] Don't promise a tolerance, fit or surface finish.
[ ] Do answer stock and size questions from your list only.
[ ] Don't promise a delivery date unless the job board shows it.
[ ] Do hand rush jobs, changes to running jobs and complaints to a person.
[ ] Don't say a fastener grade is suitable for lifting or structural use.
[ ] Do keep drawings private and never describe one customer's part to another.
[ ] Do say plainly when you do not know and when a person will reply.

Turning rules into instructions

Write each rule as a short sentence in your own voice. For example: if someone asks for a price on a turned part, say that our estimator will send one and ask for anything missing. Your agent will follow plain sentences better than long policy documents.

Add a few examples of good replies from your own chats. Real examples teach the tone better than any rule, and they keep the agent sounding like your shop.

Review them often

Rules should change as your shop does.

  • Add a rule after any awkward job, then check it worked.
  • Remove a rule that no longer fits a new machine or material.
  • Ask the estimator which rule they would add next.

FAQ

How many rules should I give my agent?

Ten to fifteen clear rules are plenty to start. Cover quotes, tolerances, stock, dates, privacy and handovers, and add more only when real chats show a gap.

What if a rule is too strict for my buyers?

Loosen it carefully after reading a few weeks of chats. For example, you might let the agent give a price for a stocked fastener while quotes for machined parts stay with a person.

Should the agent ever say no to a job?

Yes, when the part is plainly outside your size or material range and you have told it so. A quick honest no is kinder than a slow maybe.

More free tools for machine shops and fastener makers

Read the guide: Answer machine shop and fastener messages while the spindles run.