Spaces

What do slow replies cost machine shops and fastener makers?

Type in how many messages you get, how long some of them wait, and what a typical customer is worth. The calculator shows how many enquiries sit unanswered and what that costs you each month. It uses only your own figures, so the answer is about your business, not an average.

Runs in your browser. Nothing you enter is sent anywhere or saved.

What this calculator does

People who message machine shops and fastener makers usually want an answer now. When nobody can reply, because it is late, busy or the phone is in a pocket, some of them go to whoever answers first. This calculator turns that into numbers you can look at.

Every starting figure is an example. Replace each with your own, and be honest: a rough guess you believe is more useful than a precise number you do not.

Every starting figure is an example. Change each one to your own.

Under your assumptions

Enquiries that wait, a day6
Enquiries that wait, a week42
Enquiries that wait, a month180
Customer-hours spent waiting, a day60
Sales value riding on those enquiries, a month1,080
Of which you expect to lose, a month270
Of which you expect to lose, a year3,285

Money is in the currency you used for order value. Monthly figures use a 30-day month. These are estimates from your own guesses, not a forecast.

How to read the result

The result is an estimate built from your guesses. It is not a forecast. What matters is the size: if the yearly figure surprises you, that is worth knowing, and you can test it by checking last month's enquiries.

An AI agent can answer straight away at any hour. It does not remove the need for people: anything sensitive still goes to someone on your team.

What machine shops and fastener makers usually get asked

This page covers job shops, precision turned part makers, and makers of bolts, nuts, screws, rivets and washers. Spaces handles the messages only. Your agent reaches your job board or stock list through its own tools, and a person quotes, and decides whether a tolerance can be held.

  • Drawing attached, 50 of these in 316 stainless, what is your lead time
  • Do you have M10 grade 8.8 bolts in stock, 2,000 of them
  • Where is job 5120, my customer is waiting on it
  • Can your lathes handle a shaft 1.2 m long
  • Can you hold plus or minus 0.02 on the bore

FAQ

Is this calculator accurate?

It is only as accurate as the figures you type in. It does not use industry averages. Check your guesses against last month if you can.

Does it save what I enter?

No. Everything stays in your browser and is gone when you close the page.

Can the agent read a drawing?

It can receive the file and note what is missing. How much it understands depends on your agent, so a person should check anything technical.

More free tools for machine shops and fastener makers

Read the guide: Answer machine shop and fastener messages while the spindles run.