Hand-over rules: which equipment messages must go to a person
This checklist lists the messages an AI agent for a heating, cooling or refrigeration maker must pass to a person, such as gas, refrigerant, sizing and warranty questions. It helps owners set the rules before a risky answer goes out.
Runs in your browser. Nothing you enter is sent anywhere or saved.
Before you start
An AI agent is good at routine work: sending a manual, matching a part, naming the nearest distributor. This industry also has moments where a wrong answer can hurt someone or damage a building. Gas, combustion, refrigerant and live electrical work all sit on the wrong side of that line.
Go through each rule and decide if it applies to your range. Then give the final list to whoever sets up your agent, and name the engineer on each shift who takes those chats. A rule with no owner fails on the first hot Monday, when twenty messages arrive before breakfast.
Tick each one as you go. 0 of 10 done.
[ ] Any mention of a gas smell, carbon monoxide or a flue problem. [ ] Any mention of smoke, burning, sparking or a fire. [ ] Refrigerant charge, leaks, pressures or recovery. [ ] System sizing, load calculations and duct or pipe design. [ ] Electrical work, wiring changes or bypassing a safety switch. [ ] Warranty claims and whether a failure is covered. [ ] Prices, discounts, project quotes and distributor terms. [ ] A food store, pharmacy or cold chain with stock at risk. [ ] A complaint, a legal threat or a dispute with an installer. [ ] Anything the agent is not sure about.
Make the hand-over useful
A good hand-over saves the engineer the first five minutes of the call. The agent should leave a short note with the model, the serial number, the fault code, what the sender already tried and the best number to reach the site.
It should also tell the sender what happens next, in plain words: an engineer will call, roughly when, and what to leave switched off until then.
Rules owners often forget
Add these to your list if they are not already there.
- Messages about units in hospitals, labs or data rooms.
- Questions about older models you no longer support.
- Requests to share test data or drawings that are not public.
- Anyone asking whether a repair is safe to do themselves.
FAQ
Should every fault message go to a person?
No. Many fault codes have a documented first check that your agent can share. Pass the message on when the check fails, when refrigerant or gas is involved, or when the sender asks for an engineer.
Who should receive hand-overs out of hours?
Name one person or a small rota who can read urgent chats on evenings and weekends. If nobody can, tell the sender plainly when someone will reply and what to do for safety in the meantime.
Can the agent tell a sender to shut a unit off?
Only if your own safety guide says so for that situation. Otherwise the agent should hand the chat to a person straight away and not improvise advice about gas, heat or electricity.
More free tools for heating, cooling and refrigeration equipment makers
- First-reply checklist for heating, cooling and refrigeration equipment makers
- First-week checklist for heating, cooling and refrigeration equipment makers
- Weekly chat review checklist for heating, cooling and refrigeration equipment makers
- Busy-season checklist for heating, cooling and refrigeration equipment makers
- Customer privacy checklist for heating, cooling and refrigeration equipment makers
- Do and don't guide for your agent: heating, cooling and refrigeration equipment makers
- Greeting messages for heating, cooling and refrigeration equipment makers
- After-hours replies for heating, cooling and refrigeration equipment makers
- Booking and order confirmations for heating, cooling and refrigeration equipment makers
- Reminder messages for heating, cooling and refrigeration equipment makers
- Apology and complaint replies for heating, cooling and refrigeration equipment makers
- "Let me check" replies for heating, cooling and refrigeration equipment makers
- Follow-up messages for heating, cooling and refrigeration equipment makers
- Review request messages for heating, cooling and refrigeration equipment makers
- Price and quote replies for heating, cooling and refrigeration equipment makers
- Delay and stock notices for heating, cooling and refrigeration equipment makers
- Thank-you messages for heating, cooling and refrigeration equipment makers
- Hand-over notes for heating, cooling and refrigeration equipment makers
- Ready answers for heating, cooling and refrigeration equipment makers
- Holiday and closure notices for heating, cooling and refrigeration equipment makers
- Missed enquiries calculator for heating, cooling and refrigeration equipment makers
- AI agent instructions builder for heating, cooling and refrigeration equipment makers
- Auto-reply message writer for heating, cooling and refrigeration equipment makers
- FAQ answer sheet for heating, cooling and refrigeration equipment makers
- Reply speed scorecard for heating, cooling and refrigeration equipment makers
- Is your business ready for an AI agent? Quiz for heating, cooling and refrigeration equipment makers
- Message workload planner for heating, cooling and refrigeration equipment makers
- Hours saved calculator for heating, cooling and refrigeration equipment makers
- Enquiry-to-customer value estimator for heating, cooling and refrigeration equipment makers
Read the guide: Answer contractor and owner messages for HVAC and refrigeration makers.