Spaces

Order and sample confirmations for spring and wire makers

These confirmation messages repeat the part, quantity and date back to a spring or wire product customer, so any mistake is caught before a run starts. Fill in your details and copy the one you need.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

In this trade a small slip becomes a whole batch of the wrong part. Wire diameter, free length, finish and quantity all need to match what the buyer meant. A short confirmation that repeats the facts gives them a last chance to say wait, that is not right.

Fill in the part and the date below, then copy the message that fits. Each confirmation repeats the key facts in plain words and asks for a simple yes, so you have it in writing before the machines start and before any wire is cut.

Confirming an order

Thanks for your order with [business]. To check: [part], [quantity], ready by [date]. If any of that is wrong, please tell us now. Otherwise reply yes and we will schedule the run.

Confirming a sample request

Hello, [business] here. We will send a sample of [part] and plan to post it by [date]. Quantity for the sample is [quantity]. Please check the address is right and reply yes.

Confirming a repeat order

Thanks, we have your repeat order at [business]: [part], [quantity]. We expect to have it ready around [date]. Reply yes if the drawing is unchanged since last time.

Confirming a quote has gone out

Hi, your quote for [part], [quantity], has been sent from [business]. It is valid until [date]. If you would like to go ahead, reply here and we will confirm the details.

Confirming a change

Thanks for the update. We have changed your order at [business] to [part], [quantity], ready by [date]. Please read it once more and reply yes so we know it is correct.

Why confirm in writing

A confirmation message is cheap insurance. If a customer later says they ordered a 2 mm wire and you made a 3 mm one, you can point to the chat where they replied yes to the exact description. That protects them as much as you.

It also catches honest confusion. Buyers mix up outside and inside diameter, and left and right hand windings, all the time. Seeing the words again in your message often makes them spot the mistake before anything is made.

What to include every time

A good confirmation covers these points.

  • The part described by its main measurements or part number.
  • The quantity and any finish, such as plain or galvanised.
  • The date, as an expected date and not a promise unless a person confirmed it.
  • A simple question that gets a yes or a correction.

FAQ

Should confirmations list every measurement?

Include the ones that define the part: wire diameter, outside diameter, free length and type. For repeat items, the part number and a note that the drawing is unchanged is usually enough.

Can an agent send order confirmations?

It can, if it reads the details from your order sheet. A person should confirm any date or change that affects the machine schedule before the agent repeats it to the customer.

What if the customer does not reply yes?

Wait a sensible time, then send one polite nudge. They are expecting to hear from you, so that is fine. Do not start the run until you have the reply or a clear instruction.

More free tools for spring and wire product makers

Read the guide: Answer spring and wire product messages without losing the drawing.