Spaces

Weekly chat review checklist for spring and wire makers

This weekly checklist helps a spring or wire product maker review the chats an AI agent handled, spotting wrong measurements, missed hand-overs and gaps in the guide. It takes about twenty minutes.

Runs in your browser. Nothing you enter is sent anywhere or saved.

Before you start

In a spring and wire shop, small mistakes in a message grow into scrap on the floor. A wire diameter misread by a tenth of a millimetre, or a quantity typed wrong, becomes a batch no one can use. A weekly look at the chats catches these slips while they are still cheap.

Set aside twenty minutes at the same time each week. Open the week's chats, work down the list, and write one change in your guide for each problem you find. Share the notes with whoever handles the hand-overs so the whole team learns together.

Tick each one as you go. 0 of 10 done.

[ ] Read five chats from start to finish, picked at random.
[ ] Check every chat where a measurement or quantity was noted.
[ ] Count the chats handed to a person and note why.
[ ] Look for any load, fatigue or safety answer the agent gave itself.
[ ] Check that every hand-over note held wire size, quantity and use.
[ ] Find chats that stopped without an answer from the customer.
[ ] Look for questions the agent could not answer.
[ ] Check the replies against any change in stock, lead time or finish.
[ ] Note any repeat customers who asked by part number.
[ ] Write down one change to make before next week.

What to do with what you find

Keep a simple log with three columns: what went wrong, why, and the change you made. After a month you will see patterns, such as customers always confusing outside diameter with inside diameter. Then a clearer measuring picture fixes it for good.

Share one good chat with your team each week as well. When the agent handled an awkward torsion spring enquiry well, point to it. People copy what they can see working.

Signs the guide needs work

Watch for these during the review.

  • Customers asking the same follow-up after every reply.
  • Replies that read well but leave out the sample policy.
  • Handovers about things your team could safely let the agent answer.
  • Quotes that arrive without a drawing or measurements.

FAQ

How much time should the weekly review take?

About twenty minutes for a small shop. Read a handful of chats, scan the handed-over ones, and note a single change. Busier shops can split the review between the sales and the engineering side.

Who should do the review?

Ideally the person who knows your products best, such as an estimator or the owner. They can spot a wrong measurement or an overconfident reply that a newcomer would miss.

What if I find a serious mistake in a chat?

Contact the customer yourself straight away, correct it calmly, and fix the guide that same day. Then add the case to your do-and-dont list so the agent hands over next time.

More free tools for spring and wire product makers

Read the guide: Answer spring and wire product messages without losing the drawing.